ACTi KCM-5511 Manuál

Outdoor-Ready Box Hardware Manual KCM-5211E, KCM-5311E KCM-5511, KCM-5611 Ver. 2014/10/15

www.acti.com Hardware Manual 10 Step 2: Prepare the Flex Conduit 1. From the network side, insert the Ethernet cable and other cabl

www.acti.com Hardware Manual 11 4. Detach the conduit gland from the back cover of the camera as shown below: 5. I

www.acti.com Hardware Manual 12 7. Attach the clamping nut to complete the cable solution. NOTE: Make sure the clamping nut is

www.acti.com Hardware Manual 13 2. When done, close the back cover by tightening the three (3) screws. 3. Connect the other

www.acti.com Hardware Manual 14 Step 4: Install the Camera Install the camera to the bracket (not included in the package). NOTE:

www.acti.com Hardware Manual 15 Other Connections This section describes the procedures in preparing the external devices that you c

www.acti.com Hardware Manual 16 3. Connect the wire with the white stripe to the 12V pin and the other to the GND pin. 4. Tig

www.acti.com Hardware Manual 17 Connecting DI/DO Devices (Optional) Depending on your surveillance needs, you may connect digital in

www.acti.com Hardware Manual 18 To connect input devices (DI), map the pins to one of the pin combinations below: Device Pin Mappi

www.acti.com Hardware Manual 19 High Voltage DO Device Connection Even though the camera provides 12V power, this may not be enough

www.acti.com Hardware Manual 2 Table of Contents Precautions 3 Safety Instructions ...

www.acti.com Hardware Manual 20 Connecting a Serial Device (Optional) The camera can be connected to a Pan-Tilt (PT) Scanner (Pan-Ti

www.acti.com Hardware Manual 21 documentation or contact the manufacturer to verify the corresponding pin labels and ensure proper w

www.acti.com Hardware Manual 22 Accessing the Camera Configure the IP Address In order to be able to communicate with the camera fro

www.acti.com Hardware Manual 23 If you work with our cameras regularly, then there is even a better way to discover the ca

www.acti.com Hardware Manual 24 Use the default IP address of the camera If there is no DHCP server in the given network, the user m

www.acti.com Hardware Manual 25 Manually adjust the IP addresses of multiple cameras If there are more than one camera to be used in

www.acti.com Hardware Manual 26 Access the Camera Now that the camera and the PC both have their unique IP addresses and are under

www.acti.com Hardware Manual 27 Upon successful connection to the camera, the user interface called Web Configurator would appear to

www.acti.com Hardware Manual 3 Precautions Read these instructions You should read all the safety and operating instructions before

www.acti.com Hardware Manual 4 Safety Instructions Don’t use the power supply with other voltages This device is likely to be damage

www.acti.com Hardware Manual 5 Safety Check Upon completion of any service or repairs to this video product, ask the service technic

www.acti.com Hardware Manual 6 Introduction Package Contents Camera QIG Terminal Blocks for P

www.acti.com Hardware Manual 7 Physical Description 1) MicroSDHC Card Slot Insert a MicroSDHC card here for local recording on th

www.acti.com Hardware Manual 8 6) Reset Button The Reset button is used to restore the factory default settings of the camera, incl

www.acti.com Hardware Manual 9 Installation Procedures Before installation, prepare the following tools and accessories which are no